printable version
Locking system switch, removal and installation of a cable lock
Lock switch between AT and locking the ignition provides the following: - When the ignition switch is in the ?«ON?», the selector lever can not be derived from position ?«P?» with the brake pedal;
- When removing the ignition key selector lever can not be derived from position ?«P?»;
- The ignition key can not be removed until the selector lever is not set to ?«P?».
Removal and installation of a cable Fixing the cable lock
| - Release the slider of the adjusting holder, squeezing the locking tabs slide.
- Remove the cable jacket from the bracket and disconnect the cable from the lock rod.
- Remove the holder with the ignition lock cylinder and remove the cable.
- Installation is in the reverse order.
- After fixing the cable to the ignition lock set to position ?«LOCK?», and set the selector lever to position ?«P?», and only then set the stock.
|
|
|