REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
		Brakes
		Suspension and steering
			General recommendations and safety measures
			Front suspension
				Removing and installing, disassembling and assembling the strut
				Removal and installation of control arm
				Removing and installing stabilizer bar
				Removing and installing subframe
			Rear suspension
			Steering
		Body
		Onboard electric
		Diagrams

printable version

Removal and installation of control arm

Components installation control arm shown in the illustration front suspension.

PERFORMANCE ORDER

Remove a corresponding wheel.
Give nuts and bolts of the ball joint suspension and remove the wishbone from the knuckle.
Give nuts and bolts fastening arm to the subframe and remove the lever.

When removing the left arm on models with AT to the bolts of giving lower subframe. For this pre-prop stretcher jack, give bolt the upper right thrust bolt of the left upper link (from the stretcher), and the sub-frame mounting bolts.

Check removing components and replace them if necessary.
Installation is in the reverse order. After installation, check the wheel alignment.

« previos page
Removing and installing, disassembling and assembling the strut

next page »
Removing and installing stabilizer bar