REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
		Brakes
		Suspension and steering
		Body
		Onboard electric
			general information
			Fault diagnosis onboard electric equipment - the general information
			Safety locks - the general information
			Relay - the general information and check of serviceability of functioning
			Windows
			Removal and installation of on-board control unit (BCM)
			Removal and installation of the horn
			Removing and installing wiper arms
			Removal and installation of rods and electric windshield wiper
			Removal and installation of glass cleaner electric tailgate
			Adjusting washers of glasses
			Removal and installation of hoses and nozzles washing of glasses
			Removal and installation of the tank and pump the liquid for washing glasses
			Removal and installation of a rain sensor (with appropriate equipment)
			Removal and installation of components of washing the lenses of headlights (with appropriate equipment)
			Replacement lamps lighting
			Removal, installation and adjustment of lighting
			Device combination
			Removing and installing the trip computer and audio unit
			Removing and installing speakers and radio aerial
			Removing and installing steering column switch and coil spring
			Removal and installation of components of the SRS
		Diagrams

printable version

Removing and installing wiper arms

Windscreen wipers

PERFORMANCE ORDER

Open the hood, lift the wiper arm and remove the arm nuts.
Give a nut and remove the lever, the driver's side first, and then - on the passenger side.
Before installing, clean landing slots lever.

Set up arms in accordance with the illustration and tighten the fixing nut with a force of 20.6 ÷ 26.5 N ??? m (A, B - 33.7 ÷ 48.7 mm).

Moisten the windshield wipers and turn.
Make sure that the windscreen wipers stop in the position shown in the illustration above.

Cleaner glass tailgate

PERFORMANCE ORDER

Raise the wiper arm and remove the arm nuts.
Give a nut and remove the lever.
Before installing, clean landing slots lever.

Set the lever according to the illustration and tighten the retaining nut to 10.8 ÷ 13.2 N ??? m (A - 25.5 ÷ 40.5 mm).

Moisten a windscreen wiper and turn. Make sure the wiper stops in the position shown in the illustration.

« previos page
Removal and installation of the horn

next page »
Removal and installation of rods and electric windshield wiper