|
|
 printable version
A battery
The battery is located on the left side of the engine compartment. Check
| PERFORMANCE ORDER | | Standard battery | | 1. In a small run of the car every 3 months is recommended to check the density of the electrolyte. | | 2. If you suspect a malfunction of the battery compare electrolit density in the cells, which should differ by no more than 0.04. Otherwise, the damaged plate, or there is leakage of the electrolyte. | | 3. If the density is different within these limits, and the battery is low, then it must be recharged. | | Maintenance-free batteries | | 4. The battery status is determined by a voltmeter or the indicator. | | 5. Battery status is determined by the color of the indicator, which depends on the type of battery (consult with the purchase). | | 6. When testing voltage voltmeter must be at least 6 hours after the last trip. Otherwise turn before checking the main beam headlights for 30 seconds. | | 7. The battery is fully discharged, if the voltage is below 12.2 V. | | 8. Remove the discharged battery and recharge. |
|
Charging
| PERFORMANCE ORDER | | Standard battery | | 1. Battery charging current equal to 0.1 of the container until the density of the electrolyte stops to change for at least 4 hours. | | 2. The battery can also be charged a small current of 1.5 A, leaving for the night. | | 3. Forced charging is not recommended. | | 4. The temperature of the electrolyte during charging should not be higher than 38 ?� C. | | Maintenance-free batteries | | 5. Batteries of this type require a long charging time (up to three days depending on the level). | | 6. partially discharged batteries can be charged with a stabilized source voltage 13,9-14,9 V for usually 3 hours to a voltage of 12.5 V. | | 7. fully discharged battery (with voltage below 12.2 V) is recommended to charge a specialist workshop, since in the long process of the charge requires constant monitoring. |
|
Withdrawal
| PERFORMANCE ORDER |  | 1. Remove the nuts and disconnect terminals (arrows) from the poles (first disconnect the negative terminal). | | 2. Unscrew the nuts and remove the clamp, unhook the studs. | | 3. Remove the battery and a plastic tray. |
|
Setting
| PERFORMANCE ORDER | | 1. Installation is performed in reverse order. | | 2. The first terminal joins a positive pole, then - negative. | | 3. Lubricate the battery terminals with petroleum jelly. |
|
The density of the electrolyte
| Above 25 ?� C | Below 25 ?� C | Fully charged battery | 1.21 - 1.23 | 1.27 - 1.29 | Charged 70% | 1.17 - 1.19 | 1.23 - 1.25 | Weak | 1.05 - 1.07 | 1.11 - 1.13 |
|
|
