 printable version
Differential
Removing the driven pinion pair and dismantling of the differential housing are associated with certain difficulties and the presence of special mounting kits, so these operations are encouraged to contact the station maintenance. The replacement of tapered roller bearings of differential see. Subsection 5.2.2.4.
Adjusting the differential
| PERFORMANCE ORDER | | 1. Adjust the differential adjustment is made similarly to the differential transmission of type 084 (see. Subsection 5.2.2.4) except for the following. | | 2. The washer of 1 mm thickness is set to the clutch and thus pressed into the outer ring of the bearing. After measurement and selection of the desired thickness shim installed in the transmission housing. | | 3. Calculate the thickness of the shim by the formula: S2 = Sn + 0,4 mm, where S2 - design thickness required shim, Sn - the measured value of the axial clearance. |
|
|
