REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf II, Jetta (from 1983 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 2 / Jetta
		General Information
		Engine
		The power supply system
		Coupling
		Transmission
		Transmission
		Front-wheel Drive
		A steering
		Suspension
		Brakes
		Body
			Front bumper
			Rear buffer
			Cover the back buffer
			Grille
			Panel Rack
			Front fender
			Lokar
			Decorative molding
			Drains
			Laths of the roof drains
			Door handles
			External door lock
			Internal door lock
			Adjusting the door lock
			Door mirror
			The upholstery of the door panel
			Glass doors
			Wind and lateral motionless glass
			The inner door handle
			Windows
			Central door lock
			Front seat
			Tailgate
			The mechanism of management of a heater
		Electrical

Front bumper

Fairings buffer (model year with 08.89 g)

1 - lower fairing;

2 - rear fairing;

3 - the screw;

4 - buffer

Mounting bracket front fender

1 - spar;

2, 3 - bolts;

4 - an arm

The side rails of the front buffer

1 - buffer;

2 - lateral support;

3 - directing;

4 - washer;

5 - the body;

I - rail on models of release till 08.1989

Withdrawal

PERFORMANCE ORDER

1. To disconnect Pads with wires turn indicators, located on the right arm of the buffer.

2. Remove headlamp washer hoses (if installed).

3. Unscrew the fairing 1 and 2 (see. Fig. The fairings buffer (model year with 08.89 g)) on both sides of the car (on models of release with 08.1989 g).

4. Remove bolts 2 and 3 (see. Fig. Mounting bracket front fender) on both sides of mounting brackets 4 buffer to the side members 1.

5. Remove the buffer 1 (see. Fig. Side guides of the front buffer) by pushing it from the side guides 3.

6. If the buffer will be removed brackets - pre-mark their mutual position.

A warning

With 8.89, the redesigned side guides (see. Fig. Side guides of the front buffer).

Setting

PERFORMANCE ORDER

1. Set the buffer by typing it into the side rails 3.

2. Install bolts 2 and 3 (see. Fig. Fixing bracket front buffer) on both sides torque 82 Nm (8.2 kgf-m).

A warning

Bolts should twist only the same type that were installed before disassembling.

3. Pull the connector with wires turn indicators through the holes in the bracket buffer and attach it to the connector.

4. Install the headlight washer hose (if available).

5. Install cowlings 1 and 2 (see. Fig. The fairings buffer (model year with 08.89 g)) on both sides of the car (on models of release with 08.1989 g).

« previos page
Body

next page »
Rear buffer