printable version
Anti-roll bar
MODELS GOLF CARAT, GTI, GTO with sports CHASSIS AND JETTA Withdrawal PERFORMANCE ORDER | 1. Set the parking brake. | 2. Loosen the wheel bolts. | 3. Lift the front of the car and establish on support. | 4. Remove the wheel. | 5. Remove nuts 23 (see. Fig. The front suspension) on both sides of the stabilizer 5. | 6. Establish a support beam under 13. | 7. Remove the bolts 12. | 8. Loosen the screws 32 and 15 to set the levers to the horizontal position. | 9. Remove the stabilizer 5 with 8 struts and rubber pads 6. | 10. Remove the rack from the 8 stabilizer 5. | 11. Remove the rubber pads from the stabilizer 6. |
|
Setting PERFORMANCE ORDER | 1. Inspect the stabilizer. If it is bent, it must be replaced. | 2. Inspect the rubber pads 6 and the hinges 10 and 11. If they are worn or damaged, replace them. | 3. Install anti-roll bar is carried out in reverse order. | 4. Install the hinges 10 and 11 to small diameter hinges 9 cups and cups of 9 hinges should be directed shoulder in the opposite direction. | 5. Tighten the bolt torque of 32 130 Nm only after the installation of the car to the ground, shaking his car several times in an upright position and rolled it several times back and forth. |
|
|