1. Install the knuckle 27. |
2. Tighten the screws 28, with its head should be pointing toward the front of the vehicle. |
3. Install the mounting bracket 19 to the previously made marks on the knuckle 27 and tighten the nut 20 95 N ?� m (or torque 80 Nm for nuts established until February 1990). |
4. Install the brake caliper 41 (see. P. 9, sub-section 10.7). |
5. To put on the new tie rod clamp 5 and 6 mud cover. |
6. Tighten the inner ball joint 4 to a point made earlier in the thread of the rack 8, or at a distance of a = 70.5 mm (see. Fig. The steering mechanism). |
7. Install the stabilizer bar (if available, see. Subsection 9.1.6). |
8. Install the axle shaft (see. Subsection 7.2). |
9. Install the wheel and lower the car to the ground. |
10. Tighten wheel torque of 110 Nm. |
11. Check the wheel alignment (see. Subsection 9.1.7). |