printable version
Outer CV Joints
Outer constant velocity joint (CV joint) 1 - a collar; 2 - sex; 3 - mud cover; 4 - a collar; 5 - separator; 6 - holder; 7 - minor axis; | 8 - the case of the hinge; 9 - a lock ring; 10 - ball; 11 - cone ring; 12 - spring washer; I - the position of the spring washer when installing |
The position of the separator with the clip when removing and installing | I - the position of the separator with a holder during removal; II - the position of the separator with a holder after installation and rotation (arrow) |
Withdrawal Dismantling A warning Individual parts replaced SHRUS unacceptable. CV joints are replaced only in gathering.
PERFORMANCE ORDER | 1. Rinse the hinge in kerosene. | | 2. Mark the relative position of the separator 2, the cage 1 and the housing 4 at its end. | 3. Turn the separator 2 and the holder 1 by gently tapping the end of the separator mandrel soft metal, to position 3 when the ball leaves the track. | 4. Squeeze bulb 3 of the separator 2 of soft metal mandrel. | 5. Squeeze the remaining balls in a similar way. When jamming separator with a holder gently tap the hinge housing. | 6. Turn the separator with a holder perpendicularly to the surface of the housing so that the two elongate box separator is positioned against the housing projections (position I), and with a holder to remove the separator from the housing (see. Fig. The position of the separator with a holder to remove and install). | 7. Drown one of the protrusions holder, turning it into an elongated box separator and roll cage. | 8. Rinse thoroughly all parts of the hinge in kerosene and to check their status, paying particular off the radar on the ground surface of the tracks and spherical surfaces of the separator and balls. A warning Cracks, chips and corrosion is unacceptable. At deterioration of working surfaces of racetracks more than 0.1 mm, and the presence of the above defects to replace the hinge assembly.
|
|
Assembly PERFORMANCE ORDER | 1. Assemble the outer constant-velocity joint is produced in reverse order. Insert prior to assembly into the body hinge 45 g grease G-6,2. | 2. Take into account when assembling the label mutual arrangement made earlier. | 3. Turn the separator with a holder after the installation in the case of the hinge to position II (see. Fig. Position of separator with a holder when removing and installing). | 4. Insert the balls for the convenience of the opposite sides. |
|
Setting
|