printable version
Anti-roll bar
Removal of the stabilizer in the following order: - Hang out and fix on support struts front of the vehicle; - Set the jack under the central part of the crossbeam and raise the jack so that the weight of the beam perceived jack; - Unscrew the mounting suspension stabilizer bar to the cross beam and the body. Front bolt also secures the rear Hob control arm; - Remove the nut and disconnect the connector stabilizer stabilizer bar from the control arm. Plates of sheet metal with rubber feet are installed on both sides of the cross arm. When installing the parts must be installed in its place. Tapered side silent blocks located on the side plates of sheet metal, while the folded edge of the plates directed in the opposite direction from the silent blocks; - Lower stabilizer bar and remove it from the vehicle; - Check the condition of the stabilizer bar and replace it if necessary; - In the case of wear or strong deformation, replace the bushing stabilizer attachment to the body. Install stabilizer spend to sequences, return to removal. Tighten the mounting nuts of the stabilizer in the "car on wheels."
|