Check the ATF level and top-up

At check of level ATF must be sure to replace the O-ring screw plug to control the level ATF (Fig. 3.69).

Switch off the engine.

By the beginning of checking ATF temperature must not exceed 30 ?� C.

Transmission dolzhnarabotat not in emergency mode.

The car must be horizontal.

Selector lever must be in position ?�P?�.

Start the engine.

Raise the vehicle.

Place a tray under the gearbox.

At a temperature of 35 ?� C to 45 ?� C, remove the plug in the sump level check ATF (Fig. 3.70).

Drain located in the bypass pipe (Fig. 3.71).

Tighten the drain plug with a new lip seal with a torque of 15 Nm. This check of level ATF is completed.

If ATF drips out of the hole: it is necessary to add ATF.

Topping the ATF

With the engine running, screw hand tight adapter for oil filling.

Pour 1 liter of ATF.

Disconnect the adapter to fill the oil from the high speed lock and check for any sign of fluid from the hole in the adapter.

Esl ivytekaet, oil refilling is required.

Allow to drain ATF so that individual drops drip.

Tighten the drain plug with a new lip seal with a torque of 15 Nm. This check of level ATF is completed.

If posleetogo ATF fluid drips: need refilling more than one liter of liquid.