 printable version
Installation manual, Passat 2006 with "external" radiator cooling ATF
Installation is basically the reverse order, but must comply with the following instructions. Check, if pressed on the flange of the motor centering sleeve. Check the fit of the metal pads (engine-KP). The gasket must adhere to the engine over the entire circumference, if lightly pressed with both hands to the motor. If it appears at the top of the engine, this means that for the engine gasket leash hung incorrectly. Engine and gearbox must be installed on the support of the power unit without straining. For information on how this should be stated in correctly perform. Torque. Replace all screws on the left support bracket assembly. First, the new screw bolts by hand. When installing the screw console to gearbox with a torque of 40 Nm + 90 ?�. For tightening both bolts console to the car between the two screws with a screwdriver can ototregulirovat "old land" bolts. These two large bolts are tightened with a torque of 60 Nm + 90 ?�. Replace the O-ring on the pipeline fluid ATF. Screw the ATF pipes to the gearbox. Attach two of the wires. After installation, check the fluid level ATF.
Pipelines zhikosti ATF, ?�external" radiator cooling the ATF and an additional cooling radiator the ATF
| Fig. 3.92. Piping the ATF on the gearbox: 1 - ATF fluid conduit; 2 - ATF fluid conduit; 3 - a nut
|
| Fig. 3.93. External cooling radiator fluid ATF: 1 - a bolt; 2 - a nut; 3 - an external radiator cooling fluid ATF; 4 - a bolt; 5 - ATF fluid conduit; 6 - ATF fluid conduit; 7 - a nut
|
| Fig. 3.94. Additional radiator cooling fluid ATF: 1 - additional cooling radiator fluid ATF; 2 - a bolt; 3 - a bolt; 4 - ATF fluid conduit; 5 - ATF fluid conduit; 6 - a bolt; 7 - a bolt
|
| 
