REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
			Technical data
			Lower arm front suspension
			Replace the lower arm bushing
			Replacement of the plug (G) of the lower arm
			Front stabilizer
			Rear strut
			Replacing the rear trailing arm bushings Rear suspension
			Replacing the rear control arm bushing (A and B) of the rear suspension
			Rear anti-roll bar
			The corners of the front axle
			Adjustment of a convergence of back wheels
			Tyre wear
			Anti-skid chains
			Runout
			Tightening the wheel nuts
			Shift of wheels
			Check withdrawal and course instability of the car
			Caring for aluminum alloy wheels
			Troubleshooting
			Diagnosis tire wear
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Rear anti-roll bar

PERFORMANCE ORDER

1. Remove the rod stabilizer bar.

2. Check the torque that must be applied to crank pin of the spherical hinge of draft of the stabilizer.

If there are cracks in the protective cover, replace it and add grease in the joint.

Several times rocking from side to side of the hinge pin of the spherical rod stabilizer.

Screw on the hinge pin of the spherical self-locking nut and measure torque.

Torque: 1,7-3,2 N ??? m

If the torque exceeds the allowable value, replace the stabilizer rod.

If the torque is significantly lower than the allowable value, the ball joint can be reused if it is not jammed and is not excessive backlash.

3. Set the draft of the stabilizer and fix the nut so that the lower nut is located at a distance A from the end of traction.

Distance (A) from the stabilizer rod end nuts to 4-6 mm

« previos page
Replacing the rear control arm bushing (A and B) of the rear suspension

next page »
The corners of the front axle