add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Accent
Home
 
Hyundai
Accent
Instructions
Engine
Greasing system
Technical data
Choice of motor oil
Oil pressure sensor
Check engine oil level
Replacing the engine oil
Changing the oil filter
SOHC engine oil pump
The oil pump of engine DOHC
Cooling
Control, reduced toxicity
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Steering
Brakes
Body
Air
Electrical equipment
Appendix
Wiring
 


Hit Counter by Digits


print page printable version

The oil pump of engine DOHC



1 - oil strainer;
2 - a bolt, 15-22 N ??? m;
3 - installation;
4 - the plug;
5 - a spring;
6 - bolt, 20-27 N ??? m;
7 - a forward sealing ring;
8 - the front cover;
9 - internal gear oil pump;
10 - External gear oil pump;
11 - a cover of the oil pump;
12 - a lining;
13 - a bolt, 6-8 N ??? m;
14 - oil pan;
15 - a lining;
16 - cork, 35-45 N ??? m;
17 - the plug;
18 - Oil filter.

Withdrawal

PERFORMANCE ORDER
1. Remove the timing belt.
2. Remove all screws on oil sump.
3. Remove the oil pan.
4. Remove the 2 bolts and remove oil strainer with oil receiving pipe.
5. Remove the front cover.
6. Remove the oil pump.
7. Remove the internal and external gear pump the oil out of the front cover, previously noting their relative position.
8. Remove the plug and remove the spring and plunger.

Check

PERFORMANCE ORDER
1. Check oil pan for cracks or damage and replace it if necessary.
2. Check the oil filter for cracks or damage and replace it if necessary.
3. Check the front cover for wear or damage in contact with the gear oil pump and replace it if necessary.
4. Check for worn or damaged gear teeth oil pump.
5. The probe measure the gap between the gear and the oil pump jack in a cover.

Maximum permissible backlash external gear of the oil pump: 0,12-0,18 mm
6. The probe measure the gap between the teeth of the gear oil pump.

Maximum permissible backlash between the teeth of the gear oil pump: 0.001-0.003 mm
7. The metal ruler and a feeler gauge, measure the side clearance of the oil pump gear.

Maximum permissible backlash of rotors of the oil pump: 0,04-0,085 mm

Setting

Oil pump

PERFORMANCE ORDER
1. Install the outer and inner gear of the oil pump in the front cover, pre-aligning the marks made previously.
2. Install the oil pump cover and secure it with screws. After tightening the bolts, make sure that the gears are turned easily and smoothly.

Tightening torque: 6-8 N ??? m

3. Install a safety valve, a spring and screw cap, having tightened its demanded moment. Before installation grease relief valve engine oil.

Torque: 40-50 N ??? m





« previos page
SOHC engine oil pump
next page »
Cooling

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.