add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Accent
Home
 
Hyundai
Accent
Instructions
Engine
Greasing system
Cooling
Technical data
Checking the tightness of the cooling system
Checking coolant density
Ribbed Belts
Tubes and pipes of the cooling system
Water Pump Engine SOHC
The water pump of engine DOHC
Radiator
Radiator cap
Thermostat SOHC engine
Thermostat engine DOHC
Control, reduced toxicity
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Steering
Brakes
Body
Air
Electrical equipment
Appendix
Wiring
 


Hit Counter by Digits


print page printable version

Water Pump Engine SOHC



1 - a bolt, 8-10 N ??? m;
2 - the water pump;
3 - installation;
4 - bolt, 12-15 N ??? m.

Withdrawal

PERFORMANCE ORDER
1. Disconnect the negative battery terminal. Drain the coolant into a suitable container and disconnect the hose from the union exit coolant water pump.
2. Remove the V-ribbed belt and the water pump pulley.
3. Remove casings of a gear belt and a tension roller of a gear belt.
4. Remove the bolts of the water pump, then remove the generator support.
5. Remove the water pump from the engine block.

Check

PERFORMANCE ORDER
1. Check each part for cracks, damage or wear and replace if necessary the pump assembly.
2. Turn the shaft of the water pump and check for smooth rotation in the absence of noise.
3. Check for leaks from the coolant pump. If there is a leak from the hole A faulty seal of the pump. If necessary, replace the water pump.

Setting

PERFORMANCE ORDER
1. Remove any remnants of gaskets and foreign material sealing surface of the water pump.
2. Replace the water pump new gasket, install the pump and secure it with screws.

Torque: 12-15 N ??? m

3. Set the toothed belt tensioning pulley and adjust the belt tension.
4. Install the timing belt covers.
5. Install the water pump pulley and V-ribbed belt, and then adjust the belt tension.
6. Fill in the required amount of cooling required coolant.
7. Connect the cable to the negative terminal of the battery. Start up the engine and check for leaks from the cooling system.




« previos page
Tubes and pipes of the cooling system
next page »
The water pump of engine DOHC

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.