printable version
Check power steering
Check for cracking tubes, slightly twisting their arm. Check for any traces of contact with the hose parts of the vehicle.
Filling the hydraulic power-assisted steering hydraulic fluid Fill a tank with hydraulic power assisted steering fluid recommended to the mark "MAX" on the reservoir. With a jack hang out the front wheels. Disconnect the high voltage from the ignition coil. Scroll through the crankshaft several jogging the starter (5-6 inclusions) at constant turning of the steering wheel left and right until it stops five or six times for 15-20 seconds. Connect the wires of a high voltage to the ignition coil, and then start the engine and let it run at idle. Turn the steering wheel from lock to lock to the disappearance of air bubbles in the tank of the hydraulic system of the amplifier. Make sure that the hydraulic fluid is transparent, without turbidity, and its level in the reservoir is near the mark "MAX" on the reservoir.
ATTENTION If the liquid level changes significantly when the steering wheel or a sharp rise after stopping the engine, then the air from the hydraulic system is not completely removed. Incomplete removal of the air from the hydraulic system of the amplifier will cause unwanted noise and reduce the life of the pump and other components of the hydraulic system of the amplifier. |
|