REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Matrix (2002 and 2006 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Matrix
		Operation and maintenance of car
		Engine
			Maintenance
			Mechanical (1.6L engine)
				Checking cylinder
				Removal and installation of support of the power unit
				Removing and installing engine and gearbox assembly
				Removal, check and installation of camshafts
				Removal, check and installation of the timing belt
				Dismantling, check and assemblage of the crankshaft
				Removal, check and installation of the flywheel (manual transmission) or torque converter drive plate (automatic gearbox)
				Disassembly and assembly of connecting rod and piston group
			Mechanical (1.8 l)
			Cooling system
			Lubrication system
			Power system
			The control system, fuel system and reducing system toxicity
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Removal, check and installation of the flywheel (manual transmission) or torque converter drive plate (automatic gearbox)

Withdrawal

Remove the gearbox and clutch.

Remove the flywheel.

Fig. 2.70. Flywheel and torque converter drive plate

Check

Check the condition of the contact surface of the flywheel with the clutch disc (no uneven wear or damage). Replace the flywheel if the surface is damaged or significant wear.

Measure the run-out of the contact surface of the flywheel with the clutch plate.

The nominal value of the flywheel runout: 0.1 mm.

Check the condition of the flywheel (for damage, cracks and considerable wear) and replace it if necessary.

Setting

Install the flywheel assembly and tighten the bolts specified torque.

Tightening torque flywheel bolts: 120-130 Nm.

« previos page
Dismantling, check and assemblage of the crankshaft

next page »
Disassembly and assembly of connecting rod and piston group