Elements of transmission control

1. Remove the two screws from the front panel.
2. After moving the front seats, remove the two screws securing the panel.

3. Remove the front panel with two switches, seat heaters.

4. Remove the lever.

5. Remove the two screws and remove the central panel, taking out her hand for the central part.

6. Remove the connector receptacle 12 in the central panel.

7. Remove the four screws and remove the console from the bracket.
8. Remove the wire and move wire circuit.

9. Remove the cable management clip and pin with the selector lever.

10. Remove the bolts selector lever and disconnect the connector.

11. Remove the selector lever assembly.
12. Remove the clamp and remove the collar nut Transmission.
13. Remove the control cable transmission.

14. Remove the wire and move wire circuit.

1. Apply a thin coat of grease on the inside of the sleeve regulated.
Lubricant: SAE SAEJ310, NLGI ?��0

2. Move the selector lever and the transmission range switch in position N and install the control cable transmission.

3. When connecting the control cable mounting bracket to the gearbox, install the clip so that it came into contact with the control cable in the position shown in the figure.

4. Install the selector lever and connect the connector.
5. When connecting the control cable mounting bracket to the selector lever, set the clip so that it came into contact with the cable management.
6. Install the control cable, cable insulation and a mounting bolt rope move.
7. Install the console and replace the eight screws.

8. Connect the wall socket, set the central panel and replace the two screws.

9. Install the panel of the lever.

10. Replace the central panel, two seat heater switch.