1. Connect the scanner HI - SCAN with diagnostic connector.
2. Read fault codes.  | The memory (RAM) can be written 8 fault codes in the order of their appearance. The same DTC can not be written as many times as the fault occurs at the same time. If there is a fault, after recorded in the memory 8 fault codes, fault codes will be erased, since the codes have been written in the first place. Do not disconnect the battery, do not consider all of the recorded fault codes as they will be erased when the battery is disconnected. |
3. If the system is activated and the transmission is locked in third gear, will be written into the RAM DTC. In this case, it can be recorded in the three memory diagnostic trouble code.
4. Cancellation happen if a gearbox is locked in third gear, the ignition key is turned to OFF, DTC recorded in RAM.
5. Storing diagnostic codes. - Up to 8 elements of the diagnosis, and 3 points can be stored.
- If the storage capacity is exceeded the diagnosis and points will be overwritten starting with the codes that were written in the first place.
6. Removal of diagnostic codes. - Automatic deletion
All diagnostic codes are deleted from the memory through 200 times after the ATF temperature to 50 ?� C within reach after storing for the best diagnostic code. - Forced removal.
Memorable diagnostic codes can be deleted using the scanner HI - SCAN, if the following conditions are satisfied: - ignition is switched on;
- no pulses from the angle sensor of the crankshaft;
- no pulses from the speed sensor of the driven shaft;
- no pulses from the vehicle speed sensor;
- Fault function is not working.
|
