1. Remove the cap of the brake fluid reservoir. Remove the wheel. Inspect the brake disc for wear or damage. |
| 2. Push the plunger deeper into the caliper using the clamp. |
| 3. Clean the brake mechanism from dust and dirt. |
| 4. Remove the caliper mounting bolt (arrow, top arrow Set screw connection banjo brake hose). |
| |
5. Lift the caliper (left) and secure the caliper position by a length of wire (right). |
| 6. Remove the anti-noise spring. |
| 7. Remove the outer brake pad. |
| 8. Remove the inner brake pad. |
| 9. Remove the fixing clamps of brake linings. |
| 10. Replace the retaining clips, if they are loosely mounted on the caliper mounting bracket. |
| 11. Apply anti-noise grease on the reverse side of the brake linings. |
| 12. Install the new inner brake lining. |
| 13. Install the new outer brake lining. |
| 14. Replace the anti-noise spring. |
| 15. Clean and lubricate caliper finger its high-temperature grease. |
| 16. Install the caliper on the brake disc and pad. |
| 17. Install the retaining bolt and tighten it to the required torque. |