REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	626
		Instructions
		Maintenance
		Engines
		Heating and ventilation
		Fuel system
		An exhaust system
		Transmissions
		Coupling and semiaxes
		The brake system
			Introduction
			Specifications
			Anti-lock braking system (ABS)
			Brake pads disc brakes
			Caliper
			Brake disk
			Brake pads drum brakes
			The wheel cylinder
			The main brake cylinder
			Brake tubes and hoses
			Bleeding brake system
			Servo
			Height and a free wheeling of a pedal brake
			Hand brake
			Cables handbrake
			The switch of an alarm bulb of low brake fluid level
		Chassis
		Body
		Electrical
		Wiring
		Tips and Tricks

printable version

Brake tubes and hoses

About every six months Inspect rubber brake hoses for cracks, leaks or traces of wear and tear. Replace the hoses if necessary. Check the condition of the brake pipe.

Inspection and replacement

PERFORMANCE ORDER


1. Loosen the connection nut (left), remove the retaining clip and disconnect a hose or tube (right).
	2. Always replace copper sealing washers connections banjo.
3. Use the brake pipe of the required diameter and size. Do not use copper brake pipes. At installation check up reliability of fastening of pipes and hoses.
4. After installation, bleed the brake system.

« previos page
The main brake cylinder

next page »
Bleeding brake system