REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	626
		Instructions
		Maintenance
		Engines
		Heating and ventilation
		Fuel system
		An exhaust system
		Transmissions
		Coupling and semiaxes
		The brake system
			Introduction
			Specifications
			Anti-lock braking system (ABS)
			Brake pads disc brakes
			Caliper
			Brake disk
			Brake pads drum brakes
			The wheel cylinder
			The main brake cylinder
			Brake tubes and hoses
			Bleeding brake system
			Servo
			Height and a free wheeling of a pedal brake
			Hand brake
			Cables handbrake
			The switch of an alarm bulb of low brake fluid level
		Chassis
		Body
		Electrical
		Wiring
		Tips and Tricks

printable version

Brake pads drum brakes

A warning

Always replace brake pads simultaneously on both wheels. Use caution when working with the brake dust containing asbestos, which is dangerous for health.

Elements drum brake

1. The clamping spring

2. Front brake pads

3. Regulator

4. The regulator handbrake

5. Return spring

6. The manual lever Tomozov

7. rear brake pads

8. A rope of a manual brake

9. The return spring

Replacement

PERFORMANCE ORDER

1. Remove the rear wheels.
	2. Remove the brake drum. If it is not removed, tighten the bolt with a diameter of 8 mm at the scheduled opening to press the drum.
3. Turn off a fixing nut and remove the rear wheel hub.
	4. Clean the brake mechanism from dust and dirt.
	5. Push the clamping spring, turn the pin and remove the spring.
	6. Remove the upper return spring from front brake pads.
	7. Disconnect the regulator and the bottom returnable spring from front brake pads.
	8. Remove the pressure spring rear brake pads.
	9. Remove the rear brake pad and remove the recoil spring.
	10. Disconnect the regulator from the spring pads.
	11. Remove pins pinch springs.
	12. Remove the cable from the handbrake lever on the rear brake pads.
	13. Lubricate the location of the brake pads with high temperature grease.
	14. Release the retaining clip with a screwdriver.
	15. Set the handbrake lever to the new block.
	16. Reinstall pins pinch springs.
	17. Connect the cable to the handbrake lever.
	18. Connect the return spring to the rear brake pads.
	19. Replace the back panel tomoznuyu block on the brakes.
	20. Install the clamp on the pin pressing spring.
	21. Attach the bottom returnable spring in the rear brake pads.
	22. Install the front brake pads in place, connect the lower return spring and set the pressure spring.
	23. Connect the return spring to the top of the front brake pads.
	24. twist knob handbrake in order to reduce the distance between the brake pads before installing the brake drum.
	25. Inspect the brake drum for cracks, scratches and wear. Check the diameter of the brake drum.
26. Installation is spent upside-down removals.

« previos page
Brake disk

next page »
The wheel cylinder