Removing and installing rear window wiper motor-reducer (T-model)

Withdrawal

1. Remove the rear wiper arm, as previously described.

2. Open the boot lid and remove the inner lining (see. Section "Body").

3. Remove the pin.

4. Disconnect the hose.

5. Remove the three screws securing the gearmotor from the lid and remove the gear motor assembly.

6. Check the rubber seal on the axis of the wiper in the trunk lid, and replace if necessary.

Setting

1. Check the seal in the lid of the trunk. If necessary, replace it, otherwise water will get into the trunk.

2. Install the gear motor assembly.

3. Place the washer hose.

4. Connect the connector.

5. For a short time the wiper switch and unplug it to come to its original position (of rest).

6. Put the wiper arm and bring to a marked glass tape position. When fitting the lever try not to hurt the washer nozzle.

7. Throw the axle nut and screw shaft. Put the cap on the nut.

8. Turn the rear wiper and check the vent. Adjust it if necessary.

9. Put the inner lining of the luggage compartment (see. Section "Body").