add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)
general info. full specifications. diagnostics. hints. tips. tricks
 Nissan Micra
Home
 
Nissan
Micra
Introduction
Controls and operation receptions
Options and car routine maintenance
Engine
The engine cooling system, heating, ventilation and air conditioning
The power supply system and exhaust
Systems of an electric motor
Manual box of a gear change and clutch
Automatic Transmission
general information
troubleshooting
Locking system switch, removal and installation of a cable lock
Removal and installation of assemblage of the control valves and accumulators
Adjustment of a cable selector
Removing and installing sensor PNP
Replacing speed sensor
Removal and installation of the AT
Repair AT
Drive shafts, steering knuckles and Hub assembly
Brakes
Suspension and steering
Body
Onboard electric
Diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of the AT



Withdrawal

Components fastening AT


PERFORMANCE ORDER

  1. Remove the battery (see chap. Systems of an electric motor) and the duct (see chap. Power supply system and exhaust).
  2. Remove the breather hose and gauge CKP (see. Section Principle of operation of the engine management system).
  1. Disconnect the sensor wiring PNP, e / m of the valve, the VSS and the ground cable.
  1. Remove the AT selector lever cable.
  2. Remove the front section of the exhaust pipe (see chap. Power supply system and exhaust).
  3. Remove the drive shafts (see chap. Drive shafts, steering knuckles and Hub assembly).
  4. Remove the oil cooler hose.
  5. Remove the starter motor (see chap. Systems of an electric motor).
  6. Remove the converter housing Bellow (see. Illustration of the fastening component of AT).
  7. While cranking the engine, remove the four screws on the drive disc and the torque converter.
  8. Establish a jack under the AT.
  9. Remove the bracket and the rear engine mounts idler arm and loosen the bolts of antibodies to the left engine support bracket (see chap. Engine).
  10. Establish a jack under the engine.
  11. Remove the bolts AT the engine and remove the AT.

Setting

PERFORMANCE ORDER

  1. Make sure that the distance between the torque converter and the end of his body is not less than 21.1 mm.
  1. Install the torque converter to the drive disc and rotate the crankshaft several revolutions to ensure smooth progress of the AT.
  1. Tighten AT: bolts ?��1 (50 mm) and ?��2 (135 mm) - with effort 31 ÷ 40 N ??? m and bolts ?��3 (20 mm) and ?��4 (30 mm) - with effort 17 ÷ 23 N ??? m.

The bolts are of different lengths, do not mix them.

  1. Install all the components acting in film.
  2. After installing, adjust selector lever cable (see. Section Adjustment of a cable of the selector), adjust the ATF level and make sure there are no leaks of it. Check the operation of AT.




« previos page
Replacing speed sensor		 next page »
Repair AT

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.