REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
			Engine cooling system
				General information and precautions
				Removal and installation of the heat sink and fan assembly
				Disassembly and assembly of the radiator fan
				Removal, check and thermostat installation
				Removal and installation of the water pump
			Heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
		Brakes
		Suspension and steering
		Body
		Onboard electric
		Diagrams

Disassembly and assembly of the radiator fan

Assembling Fan models with AT and K /


1 - Resistor 2 - Casing	3 - E / motor 4 - Impeller

Build models without fan K / V


1 - Casing 2 - E / motor	3 - Impeller

Assembling Fan Manual transmission models and K /


1 - Resistor 2 - Casing	3 - E / motor 4 - Impeller

PERFORMANCE ORDER

Remove the heatsink assembly (see. Section Removal and installation of the heat sink and fan assembly).
Remove the impeller center screw fixing.

The screw has a left-hand thread; after reversing of the screw should be replaced.

Remove the impeller and remove the 3 screws securing the e / motor of the fan.
Remove the e / motor from the housing.
Installation is the reverse order. Use the new impeller screw fastening, pre-lubricated locking sealant.
Install the heater in the cabin at its minimum temperature.
Start the motor and for 3 minutes to raise the number of revolutions 2000 rev / min.
Run the engine at idle until the radiator fan.
Check the coolant level and correct it if necessary.