printable version
Vibration damper drive shaft
Removing and installing vibration damper spend in the following order: - Hang out the front of the car and lock the support columns; - Clean the torsional vibration damper, and then turn it to provide access to the cylindrical pin, fastened together the two halves of the damper;
| Fig. 9.21. Location of the cylindrical pin to connect the two halves of the torsional vibration damper
|
- A knockout with a thin screwdriver, beat out a cylindrical pin from the damper and remove the damper from the drive shaft (Fig. 9.21). Install in reverse order of removal, and the use a new cylindrical pin. If necessary, replace the tape under the absorber.
Monolithic damper with August 1989 Removing and installing vibration damper spend in the following order: - Remove the corresponding drive shaft. Remove the shaft inner joint. - Slide on the drive shaft torsional vibration damper.
| Fig. 9.22. Torsional vibration damper arrangement (A) on the drive shaft of a = 264.5 mm for the left and the shaft 521 mm - for a right shaft
|
Install in reverse order of removal. Set the damper shaft to withstand the distance setting of the absorber (Fig. 9.22). Install the inner joint and drive shaft.
|