| 1. Loosen the screws of the rear wheels, then lift the rear of the car and fix on supports. Remove the rear wheels. |
| 2. Remove the front section thermofilter. |
| 3. Unscrew the nut and move forward main section thermofilter see. Fig. Location thermofilter exhaust system. |
| 4. Loosen the cables of a manual brake. |
| 5. Remove the retainer (D), see. Fig. Adjusting clutch cable handbrake. |
| 6. The key to hold the 13 mm flange knob from turning and loosen the adjusting sleeve until it stops. |
| 7. Slide the covers of cables of a manual brake. |
 | 8. Remove the bracket securing the cover of a cable of a manual brake caliper to the rear brake. |
| 9. Disconnect the cable of a manual brake from the lever of a manual brake caliper. At the same time, be careful not to damage the protective cover of the handbrake. |
 | 10. Release the handbrake cable from the clamps on the rear axle. |
| 11. Remove the bracket wire wheel speed sensor. |
 | 12. Remove the nuts securing the thermofilter insulation and move towards thermofilter. |
 | 13. Using a blade screwdriver, remove the retaining bracket and release the handbrake cable. |
 | 14. Use a screwdriver to remove the console cable of a manual brake. |
| 15. Remove the decorative trim rear center console. |
 | 16. Use a screwdriver through the hole in the bottom of the handbrake lever, press down the cable of a manual brake and disconnect the handbrake lever. |
| 17. Remove the cable of a manual brake. |
