 printable version
Checking the paintings wear, pressure, tread depth of tires
Checking the tire
ATTENTION When the identified deficiencies should check whether you want to replace the tire. |
Check the tire tread and sidewalls for damage, if necessary, remove foreign objects such as nails or splinters. Check the tires for uneven wear eaten only one side of the tread, porosity sidewall cuts and punctures.
Check tread By tread of the front wheels, for example, you can determine whether to adjust the angles of the wheels. Scoring on the tire tread caused by improper descent. Eaten only one side of the tread is usually the result of improper collapse. Upon detection of such improper wear to determine the exact cause, there should be measuring axes (repair type of work).
Checking tire tread depth (in Vol. H. Spare wheel) Check tread depth. The minimum tread depth of 1.6 mm.
NOTE This value may vary because of the different legislation of the countries concerned. The minimum tread depth is reached, when inserting pattern 1.6 mm thick in these places it does not overlap the tread. |
General information Table rated tire pressure is valid for standard tires, all installed on the plant size.
ATTENTION Due to safety on a car tire should be installed the same model and have the same tread pattern. On all-wheel drive cars on a mandatory basis should only be a single tire model with the same tread pattern. Otherwise, it may result in damage to the center differential. |
NOTE Regulatory pressure in the tires of a vehicle corresponding model can be found on a sticker adhered to the fuel filler flap on the reverse side or at the front B. |
Please note that values in the table actual tire pressure for cold tires. Increased due to the heating of the tire pressure is not reset. Inflate the tire according to the load. The spare wheel should be pumped at a maximum pressure provided for this vehicle. It must be remembered that after any swap or descent of any of the wheels of the car with a tire pressure display, you must do the basic setup.
NOTE The winter tire pressure should be higher than 0.2 bar. |
| 
