add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Overview
Mechanical (engine capacity of 1.6 liters)
Lubrication system
Cooling system
Fuel Injection System
The mechanical part (petrol engines of 2.0 liters)
Lubrication system
System ohlazhdeiya
Fuel system
Injection system
System of release of gases otrabotavschih
Ignition system
The mechanical part (diesel engines of 2.0 liters)
Removing Engine
Removing and installing V-ribbed belt
Replacing crankshaft oil seal on the side of the pulley
Removing and installing sealing flange on the side of the pulley
Replacing crankshaft oil seal on the flywheel side
Removal and installation of the gauge of number of turns of the motor shaft
Removing and installing needle bearing flywheel
Piston and connecting rod
Cylinder Head
Removing and installing cylinder head cover
Removal, installation and tension of the toothed belt
Removal and installation of the cylinder head
Valve gear
Removal and installation of roller levers exhaust valves
Removal and installation of roller levers intake valves
Checking the valve guides
Replacing valve stem seals
Removal and installation of camshafts
Removing and installing camshaft oil seal
Lubrication system
Cooling system
Fuel system
Turbocharging turbo running on exhaust
The direct injection diesel
Exhaust
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of roller levers exhaust valves



Remove the camshafts.
Drain the coolant.
Remove the connecting pipe EGR valve / bypass cap.
Remove the thermostat housing from the cylinder head.
Remove the locking bolts and mounting plug axis.

Installing a stripper during insertion axis
Fig. 2.308. Installing a stripper during insertion axis


Screw the puller in the insertion axis (Fig. 2.308).
Remove the insertion axis, lightly tapping.
Installation is performed in reverse sequence, with the following.

NOTE
Operated roller levers places do not change.

Insert the plug-in axis of the cylinder head and the roller lever.
Tighten the fixing bolt insertion axis with torque 10 Nm.
Replace the screw plug and tighten the new locking bolt with a torque of 10 Nm.




« previos page
Valve gear
next page »
Removal and installation of roller levers intake valves

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.