add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Transmission
Overview
Differences clutches
Bleeding the clutch assembly
Removing and installing the support bracket
Removing and installing servopruzhiny
Removing and installing clutch pedal
Removing and installing master cylinder
Hydraulic clutch
Removal and installation of the working cylinder
Installing the drive gear
Removing and installing clutch production Sachs
Removal and installation of the production of LuK clutch
Check clutch
Repair of the drive gear
Removal and installation of the cuff with a button switch and noise insulation
Removing and installing control cables - parts and components
Removal and installation of the drive gear
Adjusting drive the drive gear
Manual Transmission
Automatic transmission
Drive Train
Tables
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing clutch pedal



Withdrawal
Remove the support bracket, Passat.
Remove the support bracket, Eos.
Carefully secure the support bracket in a vise with protective jaws.

The clutch pedal
Fig. 3.14. The clutch pedal


Remove the clutch pedal 1 with the support bracket 3, which remove the nut 2 and remove the screw 5 (Fig. 3.14).
Slightly tilt the clutch pedal forward and remove servopruzhinu 4 of the support bracket.
Using tongs, remove the fixation of the clutch pedal to the master cylinder.

Removing the clutch pedal
Fig. 3.15. Removing the clutch pedal


Remove the clutch pedal (Fig. 3.15).

Setting
Installation is performed in reverse order, with the following should be considered.

Installation mounting for traction drive of the master cylinder
Fig. 3.16. Installation mounting for traction drive of the master cylinder


Install the mounting 2 for traction drive 1 of the main cylinder (Fig. 3.16).
Push bracket into the groove on the clutch pedal 3, until you hear a click.

Position servopruzhiny
Fig. 3.17. Position servopruzhiny


Put servopruzhinu top 2 in the support bracket, with the end of the spring to hold the mounting position with the mounting tool (Fig. 3.17).
Insert the stub shaft clutch pedal 1 pallet servopruzhiny.
Slightly depress the clutch pedal, insert the screw and tighten the caulking nut.
Install the support bracket.

Tightening torques
The clutch pedal is on the support bracket (replacement of self-locking nuts) - 25 Nm.




« previos page
Removing and installing servopruzhiny
next page »
Removing and installing master cylinder

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.