printable version
Hydraulic tappet
Pay attention to the following recommendations: - After removal of the hydraulic tappets contact surface should be set down on a clean surface; - Always replace pushers completely, since they can not be adjusted or repaired; - Noise when starting the engine valve is normal. However, if it is too loud, then you need to check the pushers for this: - Start the engine and let it run for as long as the cooling fan will turn on; - Increase the engine speed to 2500 min-1 and let it run for 2 minutes;
| Fig. 53. Check the hydraulic tappet
|
- If the valves are still noisy, to determine a faulty pusher stop the engine, remove the cylinder head cover and rotate the camshaft so that its pusher cam for inspecting looking up. Then press the plunger sharpened piece of plastic or wooden stick (Fig. 53). If this gap will be more than 0.10 mm, before the valve opens, the plunger must be replaced. After installing a new pushrod engine can be started no earlier than 30 minutes. Otherwise mogutstuchat valves on the piston.
|