add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
Home
 
Volkswagen
Sharan
Introduction
VR6 engine
The two-liter engine (ADY)
Engine oil
Cooling
A fuel injection system VR6 engine
The system Simos injection 2.0-liter engine
The ignition system
Coupling
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Brakes
Adjust the brake system
Disc brakes front wheels
The brakes of the rear wheels
Machining of brake discs
The main brake cylinder
Removal and installation of the main brake cylinder
Repair of the main brake cylinder
Check of the vacuum brake booster
Bleeding the brakes
Parking brake
System ABS (Antilock Braking System)
Electrical
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.
Applications
Wiring
 


Hit Counter by Digits


print page printable version

Repair of the main brake cylinder



Securing the main brake cylinder
Fig. 327. Securing the main brake cylinder 1 - a cover of tank terminals sensor Emergency brake fluid level; 2 - float; 3 - a tank; 4 - nipple; 5 - nut 25 Nm; 6 - the master cylinder; 7 - a sealing ring; 8 - flange mount hose nozzle; 9 - the vacuum amplifier





Repair of the main brake cylinder in the event of a fault lies in its replacement with a new assembly. The only elements to be changed are the connecting sleeve 4 (see. Fig. 327), in case of detection of traces of liquid leakage, and a sealing ring 7 between the master cylinder and a vacuum booster.
When replacing couplings, do the following:
- Open the lid of the tank and using a siphon-pear pump out the liquid from it;
- Using a screwdriver shake left and right tank and carefully remove it;
- Remove the nipple;
- New grease nipple with brake fluid and insert them into the master cylinder;
- Carefully install the tank;
- Restore the liquid level in the tank and bleed the hydraulic drive system.




« previos page
Removal and installation of the main brake cylinder
next page »
Check of the vacuum brake booster

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.