 printable version
Heating System
The apparatus heating system 1. Grate the hood
2. The front inlets
3. Laying
4. The rear inlets (on
the transverse wall)
5. The right air duct
6. Instrument panel
7. Right air deflector
8. Switch the heater fan
9. Flap heater control
10. The intermediate member defroster
11. Middle duct
12. The intermediate member
13. Average air deflector | 14. A motor heater
15. Pre-heater motor of resistance
16. Heater
17. Shield
18. Console air deflector at the feet of the driver
19. The heating controller
20. Ropes heating
21. Left air deflector
22. Left air duct
23. Deflector defroster
24. Control valve
25. Coolant Hoses
26. The clip of pipelines |
Fresh air for heating enters the cabin through the inlets and heater. This washes the air heater and the fan casing through the various valves distributed to the individual air vents. If heating is set to "Warn" - heat, the air is heated in the radiator. The heat exchanger is located in the heater and heated hot coolant. Passing on the hot air is heated lamellae (plates) of the heat exchanger and then enters the cabin.
Heating (inner temperature) is regulated by a valve which controls the amount of heat passing through the hot coolant. Air valve and the valve control lever by a flexible cable.
To enhance the heating is a four-fan motor heat. To the heater fan rotate at different speeds, the resistance connected. Resistance is at the connection board. When a fault connection board is replaced completely.
Depending on the model, in the rear compartment can be in a second heat exchanger (or the trunk).
Special equipment
As heating with the engine off and additional heating, are offered as water and air circulation heating. If you wish, you can order air conditioning. Repair of these systems requires skills and factory equipment, so the fault must apply to the service station.
|
