 printable version
Removing and installing starter for four-cylinder petrol engines
Withdrawal Chalk, markers or paint mark the direction of rotation of poly V-belt. If you are installing poly V-belt will rotate in the opposite direction, it will lead to its destruction. Loosen the screws V-belt tensioner and remove the air conditioning compressor belt from pulleys. Remove the air conditioning compressor mounting bolts, without disconnecting from it pipelines, take the compressor aside and fix soft wire.
| Fig. 18.32. Terminal locations starter for four-cylinder petrol engines: 1 - terminal "50"; 2 - the plug ?�B +?�; 3 - wire retainer; 4 - a nut
|
Remove the nut and remove a wire from the plug ?�B +?� pulling the starter relay (Fig. 18.32). Disconnect the electrical connector from the terminals "50" pulling the starter relay. Remove the bolt of the 4 wires. Remove the nut 3 starter bracket on the cylinder block. Remove the two screws and remove the starter.
Setting Installation is spent to sequences, return to removal, taking into account the following. Install the air conditioning compressor belt and adjust its tension.
| Fig. 18.33. Adjusting the tension of the air conditioning compressor drive belt: VAG 1410 - a torque wrench; 1 - Bolts
|
Set the torque wrench to the hex head mechanism of a tension belt air conditioning compressor in the "seven o'clock", create a pretension torque 30 Nm (Fig. 18.33) and in this position, tighten the bolts tensioner to 23 Nm. Tighten the starter mounting bolts to the transmission torque of 65 Nm. Tighten the air conditioning compressor to the bracket to 25 Nm.
| 
