printable version

Clutch

Clutch does not switch off (lever Manual transmission can not be translated freely in the reverse gear position and back when depressed the clutch pedal to the floor)

1. There have been a leak in the hydraulic clutch. Check the status of master and slave cylinder and all the hydraulic lines (Chapter Clutch and transmission line).
2. Bent or damaged clutch disc (Chapter Clutch and transmission line).

Coupling revolves (engine speed increase without an increase in vehicle speed)

1. The disc clutch is contaminated with oil or wiped its friction linings. Remove coupling (Chapter Clutch and transmission line) and check the condition of its components.
2. Not run-coupling disk properly. For the final break-in of the new drive may take 30 to 40 normal start of the vehicle.
3. Worn pressure plate / clutch basket (Chapter Clutch and transmission line).

When the clutch is engaged, a strong vibration

1. Zamaslen clutch disc. Remove coupling (Chapter Clutch and transmission line) and check the condition of its components. Correct any leak detected.
2. Worn engine mounts or PPC or weakening their attachment. These blocks can move slightly with the clutch disengaged. Check the condition of bearings and bolts of their fastening (head straight six-cylinder engine).
3. Worn clutch disc splined hub (clutch). Remove coupling (Chapter Clutch and transmission line) and check the condition of its components.
4. Bend the pressure plate / clutch basket or a flywheel. Remove coupling (Chapter Clutch and transmission line) and check the condition of its components and the flywheel.

Squeal or roar arise at full inclusion of coupling (the pedal is released)

Conjuring the clutch release bearing in the bearing bracket at the checkpoint. Remove coupling (Chapter Clutch and transmission line) and check the condition of the bearing. Remove all burrs and burrs, and lubricate the bearings before replacing.

Squeal or roar arise at full you turn off the clutch (pedal depressed)

1. Worn or broken release bearing (Chapter Clutch and transmission line).
2. Worn or damaged springs (or the petals of the diaphragm) pressure plate clutch basket (Chapter Clutch and transmission line).

The clutch pedal is depressed to the floor after it is released,

1. Conjuring thrust or thrust bearing. Check the condition of thrust, if necessary, remove the coupling components.
2. Make sure that you have installed the correct type of stress of a pedal.