printable version

Manual box of a gear change (Manual transmission)

Everywhere where otherwise indicated, is meant to refer to materials Head Automatic transmission.

When installed on the neutral PPC while the engine noises occur

1. Worn input shaft bearing.
2. Damaged bearing pinion driven shaft.
3. Worn bearings of the intermediate shaft.
4. Worn or damaged washer adjust the axial play of the intermediate shaft.

Extraneous noise take place in any position Manual transmission

1. Any of the above reasons and / or:
2. The PPC filled insufficient transmission oil (down its level) (see. Verification enumerated in Chapter Settings and maintenance).

, Noises occur on any specific transfer

1. Worn, damaged or chipped teeth of the gears of the transmission.
2. Worn or damaged synchronizer of the program.

There is a "jump off" transmission with higher transmission

1.   Is loose boxes on the clutch housing.
2. Between the boat and engine box hit the dirt box or shifted with respect to the engine.

When changing gear there are complications

1. Not fully depressed (off) clutch (see. Description of adjustment of coupling in Chapter Settings and maintenance).
2. Damaged pull switch, mount it weakened or broken adjustment. Perform a thorough inspection of the components, if necessary, replace defective.

Have the transmission oil leak

1. The PPC fueled an excessive amount of gear oil (description of the procedure check the oil level, see chap. Adjustment and routine maintenance). If necessary, drain the excess.
2. Needs replacing gland box or gland speedometer drive gear.