 printable version
Removal and installation of handles, cylinder lock (latch) the door lock
Door Latches | - Raise a glass window and remove the interior door trim and a water filter (see section Removing and installing interior door trim panel).
- Remove the stems from the linkage latch.
 | - Turn up the plastic retainer and remove the rods thrust latch.
|
- Give three fixing screws with heads of type TORX. Perhaps for the breakaway screws require a screwdriver shock.
 | - Give the bolt latch.
|
- Remove the latch on the door.
- Attach the latch on the installation location and screw the mounting bolts. Firmly tighten the bolts.
- Connect the latch rods rods.
- Ensure the adequacy of locking the door. In case of need make adjustment of the position of the latch (for the loosening of the screws), ensuring ease of door lock (door handle at the same time should be provided flush with the door). After installation is complete, loosen the adjusting screw rod by inserting the Allen key 5/32 inch (4.0 mm) into the hole in the end of the access door. Loosen the adjusting screw and push it up the slot for thrust slack, then tighten the screw.
 | - Insert the Allen key adjustment hole in the head, loosen the screw and slide it up the slot for a sample of slack traction.
|
|
|
The lock cylinder | - Remove the outside door handle. Disconnect draft using a screwdriver to push the holder and extract the cylinder lock of the door.
- Install in reverse order.
|
|
The external handle | - Disconnect draft of the external handle (remote drive) from the latch lock the door, give fixing nuts and remove the handle from the door.
 | - Details of the installation of the external handle and the lock cylinder the door.
|
- Place the handle in place, connect the rod and screw the nut. Tighten the nuts.
|
|
The inner knob | - Give a fixing bolt, turn the handle forward and remove the rods, then remove the handle from the door.
 | - Give screw (arrow), turn the inner knob back and disconnect the linkage rods.
|
|
|
|
