add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
Body
general information
Care body
Care made of vinyl trim panels
Care of an upholstery and rugs salon
Repair minor damage to body panels
Repair of considerable damages of a body
Service hinges and locks
Replacing windscreen and motionless glasses
Removal, installation and adjustment of position of a cowl
Removing and installing bonnet cable and its drive
Removing and Replacing the decorative panel grille
Removal and installation of a forward wing
Removing and installing bumpers
Removing and installing interior door trim panel
Removal, installation and adjustment of the position of the door
Removal and installation of handles, cylinder lock (latch) the door lock
Removing and installing window glass doors
Removing and installing door window regulator
Removing and installing center console
Removing and installing tailgate trim panel
Removal, installation and adjustment of the position of the tailgate
Replacing the tailgate stops
Removal and installation of facing of the instrument cluster
Removal and installation of facing dashboard
Removing and installing dashboard
Removal and installation of covers of the column cover
Removal and installation of rear-view mirrors
Remove the cowl grille and installation
Removal and installation of seat
Control body sizes
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Removal, installation and adjustment of the position of the tailgate



PERFORMANCE ORDER

  1. Open the tailgate and cover the painted surface of the body above the doorway old blanket or a special cover.
  2. Remove the interior trim, disunite electric sockets and remove the harnesses from the door.
  3. Circle marker flanges tailgate hinge.
  4. Ask the assistant to hold the door, remove the telescopic stops (Section Replacement stops the tailgate).
  5. Give bolts hinges and remove the tailgate from the vehicle.
  1. Give to the tailgate hinge bolts (arrows) you will need a key-type TORX.
  1. Install in reverse order. When replacing the wiring harness being careful not to cut the insulation on the sharp edges of the openings.
  2. When installation is complete, close the tailgate and check the adequacy of its location in the body aperture.
  3. If the door needs to be adjusted position, loosen the hinge screws slightly, gently shut the door and center it in the opening (drummer of the castle should be at the center of the door). Very carefully open the door and tighten the screws.




« previos page
Removing and installing tailgate trim panel
next page »
Replacing the tailgate stops

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.