REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
			general information
			Repair procedure which does not require extraction of the engine from the car
			Bringing in TDC position of first cylinder
			Removal and installation of the cylinder head covers
			Removal, check of a condition and installation of the rockers and bars of pushers
			Replacement valve springs, their plates and valve stem seals
			Removal and installation of the inlet pipeline
			Removal and installation of final collectors
			Removing and installing cylinder head
			Replacement of a forward epiploon of a cranked shaft
			Removal, check of a condition and installation of a cover of the distribution chain, the chain itself and its stars
			Removal, check of a condition and installation of a camshaft and hydraulic tappets
			Removing and installing sump
			Removal, check of a condition and installation of the oil pump
			Removal and installation of a flywheel / drive disc
			Replacement back radical epiploon
			Check and replacement of rubber pillows of support of the engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Replacement valve springs, their plates and valve stem seals

This procedure substantially similar to that described in Chapter straight six-cylinder engine 6-cylinder engines. Procedures for removing the cylinder head covers and rocker must be carried out in accordance with the recommendations in this chapter. Valve stem seals inlet and exhaust valves are different from each other, so when building track correctness of their installation.

Track correctness of installation of valve stem seals inlet and exhaust valves - they may differ from each other

1 - valve stem seal (screen) of the exhaust valve
2 - the intake valve stem seal

The scheme of installation of the valve springs, their plates and valve stem seals.

« previos page
Removal, check of a condition and installation of the rockers and bars of pushers

next page »
Removal and installation of the inlet pipeline