 printable version
Installation of the piston of the first cylinder to TDC of the compression stroke
The piston of 1st cylinder is set to TDC (top dead center) of the compression stroke so that during the works related to the removal of the camshaft drive belt does not violate the timing. If you violate camshaft engine will not operate normally. Expose the TDC marking on the camshaft pulley (when installing on labels on a flywheel or the crankshaft pulley in this position may be a piston or the 1st or 4th cylinder). On engines of KIA Spectra cars TDC applied to the camshaft pulleys (on the pulley shaft inlet tag ?�I?�, on a pulley shaft outlet tag ?�E?�) ... ... and on the back cover of a belt drive camshaft (projections). You will need a spanner "21". 1. Disconnect a wire from the plug ?�-?� the storage battery. |
HELPFUL HINTS Because the crankshaft crank inconvenient for a bolt attachable to the pulley, it can be done in the following ways. 1. Turn on any transfer (preferably IV) and rental car slowly to match the marks on the camshaft pulley with a label on the back of the camshaft drive belt. |
2. Turn on any transfer and hang out one of the front wheels. Then turn posted the wheel to match the marks on the camshaft pulley with a label on the back of the camshaft drive belt. |
3. Turn the crankshaft bolt for him pulley drive additional units to match markings on the camshaft pulleys and the back cover, as well as labels on a pulley drive additional units. |
4. Install all previously removed parts in reverse order of removal. |
|
| 
