REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
			General description new engines models L8, LF, L3
			The mechanical part of engines
				Engine Model L8 or LF
				Checking the contents of the CO / CH in the exhaust gas
				Measurement of engine compression
				Verify accessory drive belt
				General information and safety when removing the power unit
				Removal of sealant
				Removal and installation of the power unit
				Check actuator variable valve timing (L3)
				Removal and installation of the actuator variable valve timing (L3)
				Timing chain drive
					Preliminary operations
					Removing the mounting bolt crankshaft pulley
					Removing chain tensioner
					Removing the timing chain
					Install the timing chain
					Install the engine front cover
					Install the crankshaft front oil seal
					Installing the rubber engine mounts and mounting bracket ?��3 engine ?��3
					Installing the mounting bolt crankshaft pulley
					Install the cylinder head cover
				Removal and installation of the oil control valve (OCV) (L3)
				Checking the oil control valve (OCV) (L3)
				By operation of the spool valve (OCV) (L3)
				General repair operations on the power unit
				Check the cylinder head
				Assembling the cylinder (the beginning)
				Assembling the cylinder (the end)
				Assembling the cylinder head
				Assembling the valve timing
			Appendix 1
			Annex 2
			Appendix 3
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Install the engine front cover

Kremnievoorganichesky Apply sealant to the engine front cover, in the areas shown in Figure 2.108.

Fig. 2.108. Places applying sealant on the engine front cover

NOTE

Place the lid after 10 minutes after applying the sealant. For engines of model L3 application of sealant in the domain is not required (see. Fig. 2.108).

The thickness of the applied sealant: 2.0-3.0 mm for the area A, 1.5-2.5 mm - for the area B.

Fig. 2.109. Order of a tightening of bolts fastening the cylinder head cover

Install cover bolts to the cylinder head in the order shown in Figure 2.109.

« previos page
Install the timing chain

next page »
Install the crankshaft front oil seal