REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	626
		Instructions
		Maintenance
		Engines
			Petrol engines (1,6 and 1,8 liters)
			Gasoline 4-cylinder engine (2 liters)
			Gasoline engine V6 (2,5 liters)
			A partition of engines (1,6 and 1,8 liters)
			Bulkhead engine (2.0 liters and 2.5 V6)
			The diesel engine of 2.0 liters
			Systems of an electric motor
				Introduction
				Specifications
				Battery
				Ignition system
					Ignition coil
					The electronic control unit ignition system
					Distributor
				Battery charging system
				Generator
				The starter and the engine start system
		Heating and ventilation
		Fuel system
		An exhaust system
		Transmissions
		Coupling and semiaxes
		The brake system
		Chassis
		Body
		Electrical
		Wiring
		Tips and Tricks

printable version

Distributor

Withdrawal
PERFORMANCE ORDER
1. Disconnect the negative battery terminal.
2. Disconnect the wires from the distributor of ignition.
3. Remove the distributor cap and turn the crankshaft so that the tip of the thumb is facing the terminal cylinder N1.
4. Make a mark on the distributor directly under the tip of the thumb.
5. Also mark position of installation of the distributor on the cylinder head.
6. Turn off fixing bolts and remove the valve.

Setting

PERFORMANCE ORDER

1. Install a new O-ring on the distributor case.
2. Install the valve in the cylinder head in the same position as before removal. Check that match marks made earlier.
3. Loosely fixing bolts.
4. Further installation is spent upside-down removals. Check ignition timing and tighten the mounting bolts.

« previos page
The electronic control unit ignition system

next page »
Battery charging system