printable version

Ignition coil

Check

PERFORMANCE ORDER

Ignition system with the ignition distributor 1. Make sure the ignition is switched off. 2. Disconnect the connection of the ignition coil and check the resistance of the primary winding: on models 1993 and 1994 model years to check the resistance between terminals A and C; models 1995-1997 model years to check the resistance between terminals A and B. 3. Check the resistance of the secondary winding of the ignition coil: models 1993 and 1994 model years to check the resistance between the terminal C and the terminal high voltage wires; models 1995-1997 model years to check the resistance between terminal A and terminal high voltage wires .. 4. Replace the ignition coil if necessary. System of ignition without the ignition distributor 5. Disconnect the connection of the primary windings of the coil. Measure the resistance between the negative terminal and each of the positive terminal. 6. Mark the high voltage wires and disconnect them from the coil. Check the resistance between pairs of terminals: on models with 4-cylinder engine, check the resistance between the upper and lower pairs of terminals; on models with 6-cylinder engine, check sorotivlenie between pairs of terminals A-B, C-D and E-F. 7. Replace the coil if necessary.

Replacement

PERFORMANCE ORDER

Ignition system with the ignition distributor 1. Disconnect the negative battery terminal. 2. If the coil is integrated into the distributor, the distributor should be replaced. 3. To replace the external ignition coil, disconnect sockets of connection from the coil, turn off fixing nuts and remove the coil. 4. Installation is spent upside-down removals. System of ignition without the ignition distributor 5. Mark and disconnect the high voltage wires. 6. Turn off fixing bolts (are specified by arrows) and remove the coil. 7. Installation is spent upside-down removals.