|
printable version
The cruise control system
Cruise control maintains the set speed of the car by means of an electronic control unit, speed sensor and actuator is located in the engine compartment. The cruise control system consists of a switch, speed sensor, switch lights stoplight switch on the clutch pedal and connecting cables.
Identification and verification of conduction terminals (between terminals 2 and 3) switch the cruise control - models Ford Probe
| Position switch | Resistance (Ohms) | On | 10000 | Off | Less than 5 | Set / Acc | 680 | Coast | 120 | Resume | 2200 |
|
Identification of the terminals of the main switch of the cruise control - Mazda models
| When you turn between terminals C and D should be conductivity. | DTC cruise control Mazda models
Code | possible cause | 1 | The connecting wire, the drive system, the switch of fires of a stoplight | 5 | Fuse | 7 | The switch of fires of a stoplight | eleven | The switch of the cruise control system | 15 | The electronic control unit |
Check
PERFORMANCE ORDER | 1. Check the fuse on the cruise control. | 2. Check the operation of the switch of fires of a stoplight. | 3. Check the switch on the clutch pedal. | | 4. Inspect the vacuum hoses and check the tension of the cable system. | 5. Check the speed sensor. |
|
Switches cruise control
Check and replacement
Models Ford Probe
Mazda models
In these models, the cruise control system has built-in diagnostics.
Adjusting the tension of the cable
PERFORMANCE ORDER | | Remove the retaining clip (A) and adjust the tension of the cable so that it has a free stroke of 3 mm at (B). |
|
|
|