 printable version
Seats
Changing the position of the front seats
In length: The handle (1) to lift up, move the seat forward or backward, the handle (1) to fix. The slope of the seat cushion: Turn the wheel (2) forwards or backwards.
Seat height: lift controller (3). Sitting move forward = set higher. Seat = move back below the set. Regulator to fix. Tilt back: Wheel (4) forward or backward to rotate to the desired position. Headrest: to set the height slightly to push it forward. Adjust the head restraint so that the back of his head propped up by about ear level. This is not to pull out the headrest further stop position.
Electrically adjustable front seat
The switches are located in the front doors. The key in the lock of a steering in position 1 or 2 (in the front door open, and when the key is removed or the switch position "0"). Installing the seat and head restraint: A. Changing the position of the seat cushion. B. Change the position of the seat back. C. Change the position of the head restraint. Install the head restraint so that the back of his head propped up by about ear level. The headrest can also be adjusted manually forward.
A warning  Do not remove the headrest arm below the stop position.
Entering and memorizing the position of the seat and the head restraint: D. Enter button and memory. E. Buttons position "1" and "2". It may be administered 2 position after the installation of the seat and head restraint, press the enter button and store D, let it go, and within 3 seconds, press the 1 button positional. With 2 way button can be entered and saved another installation of the seat and head restraint. Call stored in the seat and the head restraint: When you need to install the desired positions of the seat and head restraint, press the appropriate way button until until a desired setting. If the positional button is released, the safety reasons the installation process will be interrupted immediately. Orthopedic backrest
To ensure the correct position of the spine in the back seat are airbags. The position and strength of the backrest pressure set at the 2-position lock the steering. Adjust the step switch (1), the pressure in the air cushions ("0" = no pressure 4 - maximum pressure). Position of the seat, set the switch (2) on the position "A" - the lowest to the "E" - the tallest. After the termination of a trip recently selected position is automatically set again. Heated seats The key in the lock of a steering in position 2. Enable: Press 1 = normal heating mode. The switch control lamp lights Press 2 = rapid heating. In both control switch light bulbs. After about 5 minutes the seat heating switch automatically to normal operation and in the switch will illuminate only one indicator lamp. Enable: If the switch is lit, one indicator lamp, press 1. If the switch light up 2 pilot lights, press 2. Automatic shutdown as the seat heating will occur in about 30 minutes.
A warning Seat heating requires a lot of energy, so do not keep this option on for longer than necessary.
If you turn a lot of energy consumers, or the battery is insufficiently charged, the seat heating can be switched off automatically. In this case, the indicator lamp blinks (with the rapid heating of the two light bulbs blink). As soon as the required voltage reappears, the seat heating is switched on automatically. If flickering indicator lights interfere, you can turn the seat heating switch. Front seat armrests
Position 1 - armrest raised. Position 2 - in the normal position of the seat. Position 3 - with highly tilted position of the seat. To lower the armrest press the button (4).
A warning Armrest not replace the support system for children. In a frontal impact or a collision could throw the baby through the locked front armrests. They are only used to prevent slipping when braking.
Rear seat armrest Remove the armrests of the loop. Rear head restraints Install the rear seat headrests so that the back of his head propped up on the line about the ears.
| 
