 printable version
Removing the front bumper
1. Remove the grille additional fans (if installed). To do this, turn the lock by 90 ?�. 2. Place the vehicle on a support and disconnect the connector connecting the fog lights. 3. Loosen the temperature sensor on the left side of the bumper. 4. Remove the fastening wing flaps in the bumper.
| Fig. 11.17. When assembling the bumper should be installed horizontally on the crossbar (arrows) and tighten the bolts to 20 Nm
|
5. Remove the bolts on the left and right near the radiator opening (Fig. 11.17).
| Fig. 11.18. Thanks to a sliding latch (arrow), you can adjust the gap (5 mm) between the bumper and body. Due to an error in the parking lot is usually damaged by these latches
|
6. Remove the front bumper. Lateral corners of the bumper mounted on the body by sliding the latch (Fig. 11.18 and 11.19).
| Fig. 11.19. Side bumper mounted in holders through the so-called sliding clamps
|
| 
