printable version
Removing the rear bumper
| Fig. 11.20. To remove the luggage compartment trim should be carefully remove the sliding key, inserting them in the side of the screwdriver
|
1. Remove the trunk trim. You start with a plastic trim in the rear (Fig. 11.20). 2. All sliding tabs with a thin screwdriver to loosen the rod a little pushing their middle part. Carefully remove the false key and along the edge of the trunk. Remove the plate from the right. 3. Remove both sides of the two bolts, which are about 20 cm below the rear lights. 4. If installed, remove the bolt and the center of the car. 5. Remove the bolts wing flaps in the bumper.
| Fig. 11.21. On the subsequent installation of the rear bumper, make sure that the ends of the bumper before wrapping bolts have been properly installed in the mounting holes (arrows)
|
|