printable version
Transformer torque
Kinematic scheme of the automatic transmission
| The input shaft gearbox |
Removal and installation of the transformer
For removal and installation of the transformer is necessary to remove the gearbox and drain the oil from it. Withdrawal
| - Put the transmission in a vertical position on the stand and remove the thrust gear selection.
- Insert the key into the transformer through the ventilation grille in the transmission housing and remove the plastic locking pin of the transformer by turning it to the left 1/4 turn.
- Install the handles 126 589 01 62 00 on the transformer and remove it.
|
|
Technical condition
| - If the gearbox oil burnt or contains particles cuffs, piping and flush the water-oil transformer radiator and heat exchanger.
- Upon detection of metal shavings in the oil sump gearbox replacement of transformers, since washing is not possible to completely eliminate the chips, which can cause output gearbox failure.
|
|
Setting
| - Grease a leading flange.
- Carefully insert the transformer into the crankcase, turning it alternately left and right for proper meshing gears.
- Remove the handle 126 589 01 62 00.
- Put the locking pin of the transformer and turn it clockwise 1/4 turn to lock the transformer.
- Installing the transformer then completed and before the installation of the gearbox on the car you want to put it in the correct position.
- To do this, turn the transformer so that one of the plates with threaded holes on its mating surface on the bottom.
- Grease centering on the cervix and the transducer connection to the gearbox with the engine connect rod gear selection.
|
|
|