 printable version
A steering
Design and specifications
The steering mechanism of the "screw-nut on circulating balls" (ball nut). Collapsible steering column (energy-absorbing) consists of two parts. On some models installed power steering. Characteristic | Value | The length of the corrugated pipe, mm | | 368,5-369,5 | - with the hydraulic booster
| 321,5-322,5 | Maximum allowable clearance on the diameter of the steering wheel, mm | 25.0 | Camber, hail. | of -0 ?� 20 'to 0 ?� + 10' | The longitudinal angle of inclination of the axis of rotation, deg. | 8 ?� 15'-15 ?� 9 ' | The maximum difference of the longitudinal axis of the rotation angles of the left and right, hail. | 0 ?� 30 ' | Convergence, hail. | 0 ?� 25 '(3.0 ?� 1,0 mm) |
Drive belt One multi-ribbed belt. Engine model | Width x length mm | room | M 102 | 12.5 x 750 | | | M 110 | 12.5 x 825 | | | M 115 | 12.5 x 750 | | | M 123 | 12.5 x 825 | | |
Power steering pump Power-steering pump with integrated tank is rotated Banded accessory drive belt. Oil for hydraulic steering systems The oil level in the tank should address labels "full" or be about 20 mm from the edge of the tank. Replacing the oil is not available. Characteristic | Value | Fuel system capacity, l | 14 | Used oil | ATF | The frequency of checking the oil level | every 20,000 km |
Tightening torques of the main threaded connections kgs.m Connection Type | Value | Locking nuts | | 14,0-18,0 | | 16,0-20,0 | Tie Rod End | 4,1-5,0 | Mounting damper | 4.5 | Steering gear casing | 6.9-8.0 | Pitman arm | | 14,0-17,9 | | 16,0-19,9 | Swivel arm | 8.0 | Steering wheel to the shaft | 8.0 | Power-steering pump to the bracket | 3.4 | Steering shaft to the crankcase | 2.5 | Steering column | | 0.9 | | 2.4 | Fitting the drain pipe with hydraulic pump | 3.5-4.5 | Drain pipe fitting to the crankcase steering | 3.5-4.0 |
 | On vehicles manufactured from September 1979 instead of the cone bolt nut is installed, which is replaced by a new one. |
|
