add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W123
Home
 
Mercedes-Benz
W123
Introduction
Gasoline engines
Coupling
Manual transmission
Automatic Transmission
Driveline and rear axle
The front suspension
Rear suspension
A steering
Brakes
Electrical
Body and Equipment
Removing and installing bonnet
Removal and installation of a cable the bonnet
Removing and installing rear lid
Removing and installing tailgate lock
Removing and installing tailgate (station wagon models)
Removal and installation of glass tailgate (station wagon models)
Removal and installation of gas-filled tailgate stops (station wagon models)
Removing and installing interior door trim panel
Removal and installation of mechanical door window
Removing and installing the power window
Removing and installing sliding window of the front door
Removing and installing rear door sliding window
Removal and installation of fixed glass rear door
Removal and installation of doors
Removal and installation of door opening limiter
Removal and installation of the external handle of the front door
Removal and installation of the external handle of the rear door
Removal and installation of the lock of the front door
Removal and installation of the lock of a back door
Removing and installing tailgate (station wagon models)
Door mirror
Removing and installing the fuel filler tank
Adjusting sunroof
Removal and installation of seat
Removing and installing windscreen and rear window
Removing and installing glass rear side window
Removing and installing rear window side window
Removal and installation of the instrument panel
Removal and installation of the glove compartment and the lid
Removing and installing center console
Removing and installing bumpers
Removing and installing rear storage compartment (model sedan)
Central locking system
Removal and installation of the motor heater
Removing and installing heater
Removing and installing heat exchanger
Safety and maintenance of the air conditioning system
Removal, installation and adjustment of a jet of washers of glasses
 


Hit Counter by Digits


print page printable version

Body and Equipment



Body and Equipment

Bodywork welded-metal, anti-pinch the passenger compartment, the front and rear sections, absorbing the impact energy. The body is available in versions sedan, coupe and wagon. The equipment of a body part of the sunroof and vacuum system lock the doors with the central administration. The sunroof can be manual and electric drive; in the latter case, provided the emergency manual drive. The hood, trunk lid, doors and front wings are attached to the bolts and are easy to replace. During installation, observe the relevant clearances.

The gap between the body parts to be the same throughout its length. Tolerance - 0.5 mm. Dimensions shown in the figure are in millimeters with a tolerance of ?� 0.5 mm.

Every 20,000 km grease the hinges purpose grease with a syringe. In addition, while

a car with a body type wagon tailgate hinges lubricate with engine oil. Apply a small amount of grease on the clamp and the doggie door locks.

Every 48,000 km run, check the cleanliness of the drainage holes of the body.

Every 12 months, lubricate the guides of the sunroof and check the patency of the drainage channels, pumping of compressed air from the tire pump. However, at the same time check the base body for damage and corrosion, especially the state of anti-corrosion coating underbody. If necessary, apply new corrosion-resistant coating and make the necessary repairs.





« previos page
Models "280TE" with 123,093 engines, starting with the chassis number 007 619
next page »
Removing and installing bonnet

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.